STILER petrol stump cutter powered by a 15 HP Briggs & Stratton engine.

The STILER milling machine is designed for milling and removing trunks of felled trees.

The milling disc is powered by a Briggs & Stratton engine with a capacity of 420 cm3 and 15 HP for adequate power and torque.

The grubber enables the stump to be shredded to a depth of 400 mm!

The device is only 85 cm wide, especially useful in hard-to-reach places. Replaceable teeth on the milling disc are covered with sintered carbide (widia) ensuring high hardness of the blade.

The latest model of the STILER 15 KM petrol stump cutter

Technical data:

• CE certificate: YES
• Engine: air- cooled, 4-stroke OHV, gasoline engine
• Engine power: 15.0 HP
• Capacity: 420 cm3
• Start-up: manual
• Fuel: Unleaded gasoline
• Fuel tank capacity: 6.5 liters
• Head drive: belt transmission
• Brake: disc
• Dial diameter: 35 cm
• Number of cutters: 8 interchangeable teeth, Widia
• Milling depth: up to 400 mm
• Milling width: 55 mm
• Dimensions (L x W x H): 205 x 85 x 130 cm
• Wheel: 15 "
• Ball grip: 50 mm
• Weight: 135 kg

The new model is equipped with a stronger and more efficient disc with sintered carbides.

The round cutter splits into 3 cutting edges , when one edge becomes blunt, just loosen the carbide and turn it 1/3 turn.

Thanks to this solution, we obtain 3 times longer work on one cutter.

A powerful 15 HP 4-stroke OHV engine with a capacity of 420 cm3 from the well-known and appreciated brand Briggs & Stratton allows us to mill even very hard trunks without any problems. A large reserve of power also translates into a longer service life of the machine.

The milling machine has a disc brake lever . It serves to block one wheel during milling. Thanks to this solution, the machine does not run away during operation and ensures even guidance on the trunk.

A separate disc drive mechanism is activated with a second lever.

The adjustable handle allows for milling up to 40 cm deep.

The milling machine is equipped with a handle with a 50 mm ball hitch.

The brake placed in one wheel ensures that the milling machine does not move away during operation.

The control panel is equipped with speed control, emergency switch and a switch that disconnects the ignition after releasing the handle.